Icom IC-2800H Instrukcja Użytkownika Strona 51

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 50
47
10
BAND SCOPE
Operation
The band scope function allows you to visually check a spec-
ified frequency range. Sweep range varies ±50 kHz through
±500 kHz with setting of the sweep tuning steps.
Receive audio is muted while monitoring the band scope.
Push [SWP] to cancel sweeping and receive the audio.
q Set the desired frequency as band scope center frequency.
w Push the desired band’s [
(MAIN)SCP] for 2 sec. to select the
band scope screen.
Push [CHG/L] if [(MAIN)SCP] is not displayed.
e A sweep automatically starts and signal conditions
(strengths) appear starting from the center of the range.
r Push [SWP] momentarily to begin another sweep.
appears while sweeping.
t Push [(SWP) ] for 2 sec. to begin sweeping continuously.
Push [SWP] again to cancel sweeping.
y Push [TS] to select the sweep tuning step, if desired.
5, 10, 15, 20, 25, 30 and 50 kHz sweep tuning steps are available
when a tuning step other than 12.5 kHz is selected.
12.5, 25 and 50 kHz sweep tuning steps are available when 12.5
kHz tuning step is selected.
u Rotate the desired band’s tuning dial to set the highlighted
cursor to the desired waveform and set the frequency of
the signal.
Push [CENT] to return the operating frequency to the center fre-
quency.
i Push [(MAIN) í] for 2 sec. to exit the band scope screen.
MAIN
MAIN
SCP
M
-
L
SWP
CENT
145.060
12
43
3.000
12
SCP
MAIN
TS
V/M
H
SCN
M/C
LOW
MONI
MID-LO
10k
TS
MAIN
Przeglądanie stron 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 87 88

Komentarze do niniejszej Instrukcji

Brak uwag